Pet constant temperature operating table knowledge-China Pet Care Equipment, Pet Medical Equipment, Disinfection Machine Suppliers, Manufacturers, Factory

13,Jun,2024

Pet constant temperature operating table knowledge

Operating table is an equipment platform for anesthesia and surgery. As a necessary equipment in the veterinary hand room, the use and management of the operating table directly affects the anesthesia and surgical process as well as the safety of pets. The prerequisite is to properly bind the animals on the operating table, adjust the adjustment range of the test operating table and the formation Angle of the motor. Match the best azimuth. If necessary, the thermostatic function can ensure that the pet will not lose temperature during surgery.

The use of electric operating tables
1. The lifting adopts a foot control switch. When the power is plugged in, the operating table is in a standby state. At this time, step on the foot control board to lift it up
By pressing the button, the stainless steel countertop can rise uniformly, and when the button is lowered, the countertop will automatically stop. On the contrary, when the descent button is pressed,
The tabletop descends uniformly, and when the button is lowered, the tabletop stops descending. Of course, there are limitations on the lifting range, and the maximum working height of the table of this machine is limited
The degree is about 105cm, and the minimum working height is about 60cm. Different work heights are suitable for surgical needs of animals of different sizes,
Easy to operate.

2. When the temperature is set to working mode, turn on the heating button and the temperature control instrument will light up. Set the required tables as needed
The surface temperature is generally set at 20-28 degrees. When setting, it is usually set lower and then gradually increased to avoid a slight increase in temperature
The temperature rises too quickly. After the setting is completed, the countertop can automatically reach the desired temperature and then stop heating.

3. A pneumatic tilt handle is installed below the side of the tilted tabletop. When the handle is lifted, one end of the tabletop can automatically rise and tilt
Slant, put down the handle and stop the table in the desired position; Lift the handle and press down firmly on the table to reduce the tilt angle,
Until the horizontal position, lower the handle and the tabletop will automatically lock.